ThinkRF Support

Signal Generator's 10MHz is used for factory calibration.  This applies to all RTSA products. 

The decimation of 1.

Yes, the input signal is a CW.

Power level of -44dBm is used.

For ZIF mode, the signal is injected 20Mhz from the center(tuned frequency). For SH/SHN mode, the input signal is placed at the center.  For DD mode, it&#...

Yes, HDR mode is calibrated. However, it is only calibrated when the gain is 25dB. 

For all thinkRF RTSA, the amplitude accuracy is +/- 2dB typical. Typically refers to 90% of the time, which means 10% of the time amplitude may fall outside...